Cat-house
Creator98380
Interactive 3D model: rotate to inspect, open in designer to customize
This project is shared by the community and serves as a reference and starting point. Verify all dimensions and structural correctness before cutting
Very simple cubic cat-house with two levels. The very bottom plate should become an additional cutout on all edges (42x42mm) to match the vertical posts. One of the side panels should get an additional entrance cutout (round w/o door or square for a standard cat-door). All cutouts are not possible in flatma free form.
BOttom floor is planned to be fixed with 4 metall angles, screwed to the vertical posts.
Overall material utilization factor - 59.68 %
Total edge banding length - 3.38′ (11.08 m)
Total cutting length - 6.14′ (20.138 m)
Total edge banding length - 3.38′ (11.08 m)
Total cutting length - 6.14′ (20.138 m)
| Materials | Hardware |
|---|---|
|
Laminated Particle Board 0.71″x72.05″x108.27″ (18x1830x2750 mm) ( color H1115_12) - 1 pcs. + Edge banding 1 x 19 (W1000_9) - 3.38′ (11.08 m) |
Hardware not specified |
